AnaGate CAN - Firmware Changelog

In the following you will find information about changes of actual and older firmware versions of the AnaGate CAN.

Revision History
Revision 1.1.13	08.12.2010	SWe
Added restart command.
Revision 1.1.12	25.11.2010	SWe
On boot startup the baudrate of the bridge (listen mode) is set. The parameters DataConf (default=true) and DataInd (default=false) are not always initialized. Without a SetGlobals command confirmations are not send with error codes.
Revision 1.1.11	10.08.2010	SWe
Bugfix reboot.
Revision 1.1.10	18.02.2010	SWe
Setting of LAN link mode via web interface added (Auto/10/100Mbit / Full/Half-Duplex). Link observer added (the device restarts every 10 seconds if no TCP connection is set.
Revision 1.1.9	27.07.2009	SWe
Bugfix in retrieving of serial nummber.
Revision 1.1.8	12.12.2008	ASc
Support of a user-specific CAN baud rate.
Revision 1.1.7	14.01.2008	ASc
Bug when using 10kBit and 62.5kBit baud rates fixed.
Revision 1.1.6	08.11.2007	SWe
Bug when using extended frames fixed. CAN errors are sent ot active TCP partners.
Revision 1.1.5	14.09.2007	ASc
Bugfix for fragmented TCP frames.
Revision 1.1.4	29.06.2007	SWe
Default gateway IP address is 192.168.1.3. Bugifx bridge mode: master is now initialized correctly. Counter of data packets added, displayed on web-interface.
Revision 1.1.3	13.06.2007	ASc
New feature: bridge mode.
Revision 1.1.2	20.01.2007	ASc
New API commands: OP_CAN_DIO_READ_REQ and OP_CAN_DIO_WRITE_REQ.
Revision 1.1.1	-	ASc
Initial version